best way to report +/- material on individual points on a constructed circle

Could a shortcut key be created or a quick button to turn on and off pathlines in a program? 

By showing both it gives a good indication of how angled the cylinder may be.

In the Chinese version, the following terminologies do not match the Chinese national standard:

When changes are made to scan parameters such as point density

all other probe parameters are also automatically entered in the program.

However, if parts are measured with different measuring machines but the same program, the stored probe parameters must not be changed.

As this is not possible, the probe parameters must be adjusted each time in the program.

Scanning parameters should therefore be separated from the probe parameters, as is the case in other areas.

Example A is a plane, B and C are two circles laying in plane A. I need to evaluate GD&T relative to A|B-C. B-C should be treated a as pattern. ref case #00757938

Note: B and C are measured on a thin glass lens with a Vision probe on an Optiv Reference machine: they are 2D and cannot be measured as cylinders.

This functionality is supported in other metrology software. This is very frustrating and embarrassing for my customers.

Hello PCDMIS gurus and devs.

I would appreciate if PCDMIS had admin panel where I could define all settings once and then point this admin panel to every computer where installation of PCDMIS exists this way If I wanted to change say for example speed of all machines or some other generic settings it would be done from one panel. For example layout of buttons, speed of 3D CMM, loading colors for highlighting code etc. 

You should be able to add a comment to the end of an assign line of code.

For example, currently the code is

ASSIGN/V1=10

it would be good if you could add a comment at the end to help with editing the program by adding $$ at the end, example

ASSIGN/V1=10 $$ diameter of hole 1

ASSIGN/V2=20 $$ diameter of hole 2