Found the constraint on radius/diameter of Circle, but need the constraint activated on the center of circle, to calculate actual radius/diameter on very small portion of circle.

When reporting features to Datums with MMC, the position of the features measured tend to always be zero, while the Datums the features are referenced to have a measurement? why is this? can the datums not be removed so only the features being measured show a measured value.

After Collision Detection has been run have only the Feature ID's on the Collision List appear on the Graphics Display Window.    This will cut down the amount of searching for a feature that occurs.  

Better yet, have collision detection automatically run as you offline program.

One password to access all Hexagon websites.

Instead of clicking start/end points for a scan segment to construct a feature, I would like to be able to click a CAD surface so that all hits that cross that surface are included in the feature construction

 A function to allow the program to turn off the machine servos would be very useful as operators often forget to do so when exiting an inspection program. This was an option in MeasureMax.

PC-DMIS ability to recalculate actual values of current measured values in case of probe re-qualification, i. e. when using a probe angle that wasn't qualified a long time ago and it was used in a routine that takes a long time to run.

I want to be able to calibrate probes and assign probes to the probe change rack within the Inspect Interface. I want to be able to manage probe calibrations for each program so that when I click on a measurement routine a button becomes available to calibrate all probes and angles for the associated program. Then there would be an option to manage the probe rack if needed; to assign the specific probes in the routine to the probe rack slots if not already assigned.

I want to be able to navigate within the sidebar area to inspection routines located within subfolders of the specified directory. I understand that I can go into the settings folder and call up a specific folder but it would be nice to be able to navigate the file directory within the side bar area, like Windows Explorer.

In many situations it would be better to explicitly tell INSPECT which version of PC-DMIS to run, instead of relying on the "last version that was run as administrator".