+3
Planned

Make tubeshaper software suitable for bending machines Schwarze Robitec and Wafios! We have troubles for so long now with the fact that everything is mirrored!

van der Hoorn Buigtechniek 2 years ago in Software / TubeShaper updated by neil.kay 6 days ago 3

Make tubeshaper software suitable for bending machines Schwarze Robitec and Wafios! We have troubles for so long now with the fact that everything is mirrored!

Under review

Wafios bender models BMZ & RBV both work with TubeShaper already
both need WPS 3.0 / WPS 3.2 EasyWay software running on their controllers
you would need an SV Network connection to run this


We are setting up a call to discuss this further.  Thank you for the report.  -Glenn

I think what van der hoorn means is to allow negative rotating inside TS.


So this:


TUBE-6114 SV Network option to allow for reverse rotation (left) benders


But inside tubeshaper there should be an option to "flip" the rotations. When not connected to a bender you can still use a print out to set up the bender.

Planned

This is being done for 2.0 under  TUBE-10606 All users to display reversed rotations (R) in LRA and CLRA pages