1. Hexagon Measurement Systems
  2. Metrology Software
  3. Inspect
  4. Ideas
0
Declined

If "Case" selections are used withing Program, the program Completion ring stays at 100%.

Cian 6 years ago in Metrology Software / Inspect • updated by neil kay 4 years ago • 1

If you have a "Run another Part" selection within a Program, the total measurement cycle ring does not reset back to 0%, it remains at 100%.

GOOD, I'M SATISFIED
Satisfaction mark
Satisfaction mark by Cian 6 years ago
Declined
neil kay 6 years ago

Inspect is "dumb" to the contents of the routine, so does not account for such inbuilt logic. However, in the next version of Inspect, it offers capabilities to "measure another part" at the end of execution, which you could swap to use. It also, with the playlist functionality, has the ability to multi execute a program 'n' times.

Customer support service by UserEcho