Ideeën
+4
Voltooid
Integrate leapfrog using touchprobe
sebastiaan kuiper 6 jaar geleden
in Metrology Software / TubeShaper
•
bijgewerkt door anthony vianna 3 jaar geleden •
2
Please integrate leapfrog using touchprobe. When doing the current leapfrog (measure last two straights) it is sometimes not possible to measure tubes with a very long straight (2000-3000mm) in between the bends with a "standard" tubearm. This will be possible using a traditional leapfrog (or two).
Customer support service by UserEcho
The use of a "T" to displace the tube on long straights is scheduled.
Same function as GTube.
This can already be done with a touch probe, through RDS.