+11
تم الإنجاز

Set the limit angle value to measure 180° bends

Nicolas Pétré منذ 6 سنة في Metrology Software / TubeShaper تم التحديث من قبل anthony vianna منذ 3 سنة 3

Today, 180° bends require additionnal point when the angle is higher than 178° (?).

This limit value should be editable (tupe inspectionsettings) to be able to operate the same way on slightly smaller angles (175° for inst.).

It will be useful to open this possibilities also for a all angles like an option. Also when the angle is very short (5º degrees for exmple).

We think that this topic has been addressed now in v2.1 of TubeShaper. Take a look, and let us know what you think!

خدمة دعم العملاء من خلال UserEcho