Similar function to min_circ and max_inscr of a circle.
Potentially using Std.Dev. and allowing to use points only in +% or -% of Std.Dev.
Ex. I'm using backlight only on gasket material. It would be useful if
I could Snap the line to the points that are either a minimum or
maximum (depending on material side) To avoid calculations with debris. In this example lets assume a minimum edge is what I'm looking for. I select to eliminate 75% of points on the positive side of material (75% of the standard deviation). I'm then left with 25% of the points to construct a line out of, of which are ignoring 75% of the imperfections seen on the surface.
Customer support service by UserEcho