A user parameter window that the programmer can set a value and a keystroke for commonly used functions.  

for example,  if you are programming a part with holes of varying depths you could set a letter with the parameter for the value desired.  So for the .250  you would just type "Q" in the depth area of the auto feature, "W" for .500, "E" for 1.000 and so on.  This function is a staple in modeling software.

Make a temporary clip plane automatically when selecting View Perpendicular Toggle in auto feature

This would mainly be for a series of radii on a part, where the intent is to create auto circles in a sequence and maintain a fluid motion of the cmm (no clearplanes or avoidance moves between).  Currently there is about a 2deg indent from start and end angles, which is helpful, however, when selecting cad surfaces for radii where there is a back and forth between corner and fillet radii, there needs to be a changing the start/end angles from the default (based on right hand rule i assume) and a change of the direction so that the cmm can get from one radius to the next fluidly.  What would be handy is a single toggle button (similar to the current toggle for "flip vector" for surface and angle vectors in the circle auto feature 'feature properties' area), which would simply flip the start and end angle values as well as the direction.

it was randomly generated to some features and in some programs. it make me afraid that at some points i dont trust my measurement at all. 

It would be very helpful if we could create an scan which learns the contour inside of an auto feature.

If we had an option like this, it should be very easy to create a scan and measure an feature which contur is not perfect.

Additional it is very easy to change the measurement from the default measurement strategy to scanning if you have to learn the contur.

We could use it for example at auto feature circle.

Add the ability to recall a Measurement Strategy Editor group directly in a Auto Feature Dialog box.   Should result in less opening and closing of dialog boxes.

Similar function to min_circ and max_inscr of a circle.

Potentially using Std.Dev. and allowing to use points only in +% or -% of Std.Dev.

Ex.  I'm using backlight only on gasket material.  It would be useful if
I could Snap the line to the points that are either a minimum or
maximum (depending on material side) To avoid calculations with debris.  In this example lets assume a minimum edge is what I'm looking for.  I select to eliminate 75% of points on the positive side of material (75% of the standard deviation).  I'm then left with 25% of the points to construct a line out of, of which are ignoring 75% of the imperfections seen on the surface.

Additional view settings such as adding a delay to measured vision features. 

Ex.  I measure a feature, then for a x.xx seconds (whatever I choose) the live view pauses accordingly to show the measured hits.  An additional toggle of accepted and unaccepted hits would also be nice.

The ability to modify targets without effecting alignment changes. 

Currently if I mirror a program or change an alignment - my target formula does not change it's nominal value.  Therefore the CMM drives to the wrong place.  Sometimes by 1000's of mm.  Because this is not supported in this way our company frowns upon the use of assignments.

Make it possible to open two programs side by side and have an automated feature to highlight the differences between the two i.e. if you open the Product_v1.2 program and Product_v1.4 program side by side in the same window/on same screen/ the software to be able to show the differences between the two programs by highlighting the background on the sections where they differ.

Alternatively you should be able to copy/paste and visually compare between the two programs.