0

Add "marked used" parameter set option to AutoCalibrate/Probe command

Kingsld1 منذ 2 سنة في Software / PC-DMIS تم التحديث من قبل neil.kay منذ 2 شهر 0

Add a 'mark used' parameter set option to the Autocalibrate/Probe command.


Basically I'd like the LoadProbe, Mark used, Measure sequence to be automated.   


I've never created a calibration parameter set that wasn't created from the marked use checkbox on the load probe command.  It's hard to imagine a case where I wouldn't do this unless I wanted to recalibrate an individual probe under program control.


Doing this could eliminate the possibility of forgetting to update the Parameter set when the measurement routine is updated. 



خدمة دعم العملاء من خلال UserEcho