+1

Add "marked used" parameter set option to AutoCalibrate/Probe command

Kingsld1 vor 6 Jahren in Metrology Software / PC-DMIS aktualisiert von neil kay vor 4 Jahren 0

Add a 'mark used' parameter set option to the Autocalibrate/Probe command.


Basically I'd like the LoadProbe, Mark used, Measure sequence to be automated.   


I've never created a calibration parameter set that wasn't created from the marked use checkbox on the load probe command.  It's hard to imagine a case where I wouldn't do this unless I wanted to recalibrate an individual probe under program control.


Doing this could eliminate the possibility of forgetting to update the Parameter set when the measurement routine is updated.