Lets say we have a measured cad model with a load of points taken on it. These points are coloured black on the model.
For eg.
I need to create a plane using some existing points.
From the construction toolbox I choose the plane option and I select the relevant points I need to create the plane.
After selection of these points they still remain coloured black.
Is there a way to make the selected points a different colour, so as to make identification easier, that I have selected the correct points off the model?

Be able to use Increment Moves with Virtual Machine when executing paths and for collision detection.

Show tolerance zone visualization with DRF animation of GDT constraints

Add a Calibration Timer that Forces Tip Calibration through Inspect

I am running PC-DMIS with swedish language setting and thus, the report is also in swedish. However, it would be optimal if I could change the report template language to english - just for the report as we have customers all around the world.

In order to that today, I'd have to either run PC-DMIS in english (all the time) or change language, start PC-DMIS, open my program and print the report.

Would it be possible to add the possibility for the report templates to use a different language (other resources from the .dll's) template only for printing?

Been begging for square tubes since TubeShaper came out.  I have many customers asking for this.

I measure a lot of bent tubes with copes (fish mouth cuts) on the ends of the tubes.  Would like to have the capability in TubeShaper to take  a measured bent tube (with measured cylinders on each end) and convert it to a straight state with the measured end cylinders in the correct orientation.  Then the straight tube can be exported as a CAD model so it can be used in a tube laser machine.

Currently the only method available for measuring long tubes (leap-frogging) is the "Move Tube" where it is required to measure two straights. If all straights are just too big to allow for selection/measurement of any two, this obviously won't work. Perhaps we can add an additional method, similar to that of G-Tube, where we add a displacement T-square, perpendicular to any straight.

It would be great to have the possibility to transfer Parameters at program start, right from the inspection Interface into the measuring Program, for example Batch Number, Personnel number and other input fields, similar to the already existing software "Operator Interface".

To have Legacy Textonly report supporting PC-DMIS Dimensions functionalities, or to have a similar report that is true text report and not just pictures that look like text.