Causing circular move in diameter measurements while in MODE/MANUAL is also off. There is a solution, but it would be more practical to be open.

When you Copy/Paste Parameters it will copy the whole set of parameters.

When you have let's say 100 holes which all have a different Sample Feature, and you want to change the Depth with Copy/Paste Parameters, ity will change everything, so also the Sample Feature.

So now I have to choose to manual change all Depth or manual change all Sample Feature.

Is it possible to have the option to select what parameters you want to paste?

With a popup menu or something like that?

Have an option to group features and dimensions in specific workgroup folders.

The best way I have seen this done is allowing the use of layers when dimensioning parts. 

Example Layer 1 = top view ( this would contain all dimensions from top view )

                Layer 2 = Side view ( this would contain all dimensions from the side view )

This could be done for both features and dimensions and you can easily pick and choose what features you want to have on the screen at any time. This is also good for grouping Datum features or critical features. I have used this on other CMM software's and works very well. 

When navigating through drop down menus, give the ability to quickly add an item from that menu to the toolbar shortcuts with a hotkey or simple 'right-click' sub-menu choice would be much more efficient than customizing and searching through all the menus to find the item needed.

I have currently explored the options of being able to check profile of any line on a tube centerline using Hexagons software portfolio (PC-DMIS, TubeShaper, BendingStudio) but none offers a solution.

Currently, we are using a method that mimics the use of an Absolute Arm with a fork. We are probing the start

and end planes of the pipe and probes two 3D-circles at the start and end of each straight. Then we create

intersection points, bending radii (generic circles) and export this data for processing through an external

program (made by Hexagon Nordic) for evaluation of the profile of any line for the tube centerline. 

If possible, I would like to have this natively in PC-DMIS, without the need for the external program.

Disregard any GD&T errors on the drawing, it is the yellow marked tolerance that is of interest.

BendingStudio and TubeShaper are production-oriented software and not a "metrology" software thus

not dealing with this kind of tolerancing (but more LRA).

As far as I see it, this part of profile has been "left out" and is currently missing in PC-DMIS (and other

softwares?).

As I am programing dimensional features I would like the ability to hit the comment tab and enter a note before moving onto the next dimension.   I have a costumer that wants all features numbered and those dimensions put into a report.  I try to help the individual that fills out these reports by marking the number on the PCDMIS report page.