0
Completed

Safety request by probe swivel,

Wolle 2 years ago in Software / PC-DMIS updated by neil.kay 6 days ago 3

When using executing program parts by CTRL + E, PCDMIS automatically swings to the last programmed probe position from the program.

Unfortunately alsothis position is skipped by an IF / GO command.

 Here would be a safety requestion befor the swivel useful.

GOOD, I'M SATISFIED
Satisfaction mark by Wolle 1 year ago

Make sure that is highlighted box on the left is UNCHECKED

it will give you warnings from that point on.

Hello Derek,

Thanks for the answer. However, this is only the case when the probe is called in the program sequence. But not by works with Strg + E.

In my case, if I use the command "goto", then the probe will go to the last position but this command is skipped by the "goto". And then without a message!