1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. Ideeën
0
Voltooid

Safety request by probe swivel,

Wolle 7 jaar geleden in Metrology Software / PC-DMIS • bijgewerkt door neil kay 4 jaar geleden • 3

When using executing program parts by CTRL + E, PCDMIS automatically swings to the last programmed probe position from the program.

Unfortunately alsothis position is skipped by an IF / GO command.

 Here would be a safety requestion befor the swivel useful.

GOED, IK BEN TEVREDEN
Tevredenheid notities
Satisfaction mark by Wolle 5 jaar geleden
Derek 6 jaar geleden

Make sure that is highlighted box on the left is UNCHECKED

it will give you warnings from that point on.

Wolle 6 jaar geleden

Hello Derek,

Thanks for the answer. However, this is only the case when the probe is called in the program sequence. But not by works with Strg + E.

In my case, if I use the command "goto", then the probe will go to the last position but this command is skipped by the "goto". And then without a message!

Voltooid
neil kay 5 jaar geleden

Customer support service by UserEcho