1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. Ideas
0
COMPLETADO

Safety request by probe swivel,

Wolle hace 7 años en Metrology Software / PC-DMIS • actualizado por neil kay hace 4 años • 3

When using executing program parts by CTRL + E, PCDMIS automatically swings to the last programmed probe position from the program.

Unfortunately alsothis position is skipped by an IF / GO command.

 Here would be a safety requestion befor the swivel useful.

BIEN, ESTOY SATISFECHO.
Marca de satisfacción
Puntuación de satisfacción por Wolle hace 5 años
Derek hace 6 años

Make sure that is highlighted box on the left is UNCHECKED

it will give you warnings from that point on.

Wolle hace 6 años

Hello Derek,

Thanks for the answer. However, this is only the case when the probe is called in the program sequence. But not by works with Strg + E.

In my case, if I use the command "goto", then the probe will go to the last position but this command is skipped by the "goto". And then without a message!

COMPLETADO
neil kay hace 5 años

Servicio de atención al cliente por UserEcho