0
تم الإنجاز

Safety request by probe swivel,

Wolle منذ 7 سنة في Metrology Software / PC-DMIS تم التحديث من قبل neil kay منذ 4 سنة 3

When using executing program parts by CTRL + E, PCDMIS automatically swings to the last programmed probe position from the program.

Unfortunately alsothis position is skipped by an IF / GO command.

 Here would be a safety requestion befor the swivel useful.

جيد، أنا راض
علامة الرضا من Wolle منذ 5 سنة

Make sure that is highlighted box on the left is UNCHECKED

it will give you warnings from that point on.

Hello Derek,

Thanks for the answer. However, this is only the case when the probe is called in the program sequence. But not by works with Strg + E.

In my case, if I use the command "goto", then the probe will go to the last position but this command is skipped by the "goto". And then without a message!

تم الإنجاز

خدمة دعم العملاء من خلال UserEcho