Hexagon Measurement SystemsNo matter what Hexagon measurement equipment or software you use, we want to hear your ideas and suggestions on how we can improve.
Thanks for your assistance in helping us shape the future. |
|
Variable tolerance on scans/analysis view
Some drawings show a gradual transition between profile tolerances but I'm currently unable to show this in a CMM report.
Wind Chill CAD management option
Add the ability to work with Wind Chill cad management. At least around here, Team Center is dying.
Circle evaluation with constraint
Found the constraint on radius/diameter of Circle, but need the constraint activated on the center of circle, to calculate actual radius/diameter on very small portion of circle.
Option to remove Datum feature with MMC from report
When reporting features to Datums with MMC, the position of the features measured tend to always be zero, while the Datums the features are referenced to have a measurement? why is this? can the datums not be removed so only the features being measured show a measured value.
Collision List Improvement
After Collision Detection has been run have only the Feature ID's on the Collision List appear on the Graphics Display Window. This will cut down the amount of searching for a feature that occurs.
Better yet, have collision detection automatically run as you offline program.
Scan segment construction from CAD surface
Instead of clicking start/end points for a scan segment to construct a feature, I would like to be able to click a CAD surface so that all hits that cross that surface are included in the feature construction
Recalculate actual values of measurements after probe qualification
PC-DMIS ability to recalculate actual values of current measured values in case of probe re-qualification, i. e. when using a probe angle that wasn't qualified a long time ago and it was used in a routine that takes a long time to run.
HOW CAN I LOCK FEATURES ON PROVEN PROGRAMS?
IT HAPPENED TO ONE OF MY PROVEN PROGRAMS THAT ONE AUTO FEATURE MOVED TO A NEW LOCATION BY ITSELF SOMEHOW. IT DID BREAK TIPS. WE SHOULD PREVENT IT FROM HAPPEN TO MAKE SURE PROVEN PROGRAMS ARE SAFE TO RUN.
Min Max point number matching
If the point numbers in the min/max list matched the actual feature point number then I wouldn't have to rely on the low screen resolution on graphical analysis to find where the min/max locations are.
Point Auto Trigger Cylinder length control.
Currently, Point Auto Trigger only allows for a radius to be set. This creates a cylinder that has no ends and allows for points to be taken anywhere inside the diameter created...even if its 1000mm away from the target. Often times the point is taken on the wrong side of the part by the operator... Please add a control for the max distance from the surface similar to that used for laser scanner features.
Customer support service by UserEcho
